Prosím o kontrolu z logu - Zasekaný a zpomalený PC

[jaro3]

Disk OK..

Zkus ještě ten Memtest.
http://lludvik.blogspot.cz/2011/05/memtest-40.html

http://www.pendrivelinux.com/testing-yo ... atibility/

[Reklama]

[daniel6134]

No nejdřív než udělám ten memtest tak mi musíte poradit se startem PC když ho zapnu tak misto aby naskočilo windows logo tak se PC restartuje takhle to je zhruba 3x a potom to už naběhne ale zasekne se to načítání, vubec nevím co s tím může bejt :((

[jaro3]

Stáhni si a nainstaluj WhoCrashed
otevři ho a klikni na Analyze.
Program vytvoří zprávu , zkopíruj celou a vlož prosím sem.

Protokol událostí
Ovládací panely->Nástroje pro správu->Prohlížeč událostí->Protokoly systému Windows->klikni pravým myšítkem na protokol Systém, zvol Uložit všechny události jako a ulož to jako .evtx soubor. Ten upni na http://www.leteckaposta.cz

[daniel6134]

System Information (local)
--------------------------------------------------------------------------------

computer name: MICHAL-E2561234
windows version: Windows XP Service Pack 3, 5.1, build: 2600
windows dir: C:\WINDOWS
CPU: AuthenticAMD AMD Athlon(tm) 64 Processor 3000+ AMD586, level: 15
1 logical processors, active mask: 1
RAM: 1072939008 total
VM: 2147352576, free: 2078265344




--------------------------------------------------------------------------------
Crash Dump Analysis
--------------------------------------------------------------------------------

Crash dump directory: C:\WINDOWS\Minidump

Crash dumps are enabled on your computer.

No valid crash dumps have been found on your computer

--------------------------------------------------------------------------------
Conclusion
--------------------------------------------------------------------------------

Crash dumps are enabled but no valid crash dumps have been found. It may be that there are problems which prevent crash dumps from being written out. Check out the following article for possible causes: If crash dumps are not written out.

In case your computer does experience sudden reboots it is likely these are caused by malfunctioning hardware, power failure or a thermal issue. To troubleshoot a thermal issue, check the temperature using your BIOS setup program, check for dust in CPU and motherboard fans and if your computer is portable make sure it's located on a hard surface. Otherwise it's suggested you contact the support department of the manufacturer of your system or test your system with a memory test utility for further investigation.

Check out the following articles for more information: Troubleshooting sudden resets and shut downs.

Read the topic general suggestions for troubleshooting system crashes for more information.

Note that it's not always possible to state with certainty whether a reported driver is actually responsible for crashing your system or that the root cause is in another module. Nonetheless it's suggested you look for updates for the products that these drivers belong to and regularly visit Windows update or enable automatic updates for Windows. In case a piece of malfunctioning hardware is causing trouble, a search with Google on the bug check errors together with the model name and brand of your computer may help you investigate this further.

[daniel6134]

http://leteckaposta.cz/517682328

[daniel6134]

momentálně mám ještě větší problém, když zapnu PC, nenaskočí ani uvodní logo biosu, je tam jen černá obrazovka a furt to dokola pípe nevíte co s tím může být ????

[Orcus]

http://www.computerhope.com/beep.htm